English
Getting Started
Insulation sheet
ꢀ Supplied Accessories
ꢀ Prepare the Remote
ꢀ Preparation of the Unit
Control
After unpacking, check to be sure
that you have all the following items.
• When you use the remote
control for the first time, pull
out the insulation sheet.
ꢀ Loading batteries for the Unit (The battery power supply)
Insert three batteries to each compartment (six batteries total). Be sure to match the poles (+/-) correctly.
While the AC adapter is connected to the wall outlet, the unit works without batteries.
• Remote control
• AC adapter
• CR2025 (×2) lithium coin batteries
One is loaded on the remote
control at the factory.
AC plug adapter
(Front side)
(Rear side)
R6 (SUM-3)/AA (15F) (not supplied)
PORTABLE AUDIO SYSTEM
RA-P31B/RA-P30W
Lithium
coin battery
(CR2025)
Replacing the Battery
in the Remote Control
• Insert the battery into the
remote control by matching
the polarity (+ and –)
correctly.
Open the battery compartment
cover by pressing the small tab.
Warning
Close the cover in the order shown by the numbers.
• Store the battery in a place where children cannot reach. If a child accidentally swallows the battery, consult a
doctor immediately.
• Do not recharge, short, disassemble or heat the battery or dispose of it in a fire. Doing any of these things may
cause the battery to give off heat, crack, or start a fire.
• Do not leave the battery with other metallic materials. Doing this may cause the battery to give off heat, crack,
or start a fire.
• When throwing away or saving the battery, wrap it in tape and insulate; otherwise, the battery may start to give
off heat, crack, or start a fire.
FM wire antenna
• Do not poke the battery with tweezers or similar tools. Doing this may cause the battery to give off heat, crack,
or start a fire.
• Dispose of battery in the proper manner, according to federal, state, and local regulations.
• The batteries (battery pack or batteries installed ) shall not be exposed to
excessive heat source such as sunshine, fire or the like.
ꢀ Loading batteries for the Clock
Be sure to match the poles (+/-) correctly.
Lithium coin battery
Side of the battery
Plus terminal
(CR2025) (supplied)
Plus terminal
CAUTION:
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.
Insert the battery with pushing the plus
terminal up to be sure the terminal
contacts the side of the battery.
Press the tab to open
the cover.
Close the cover in the order
shown by the numbers.
Time to change the battery
As the battery is running out, the display indication dims or the alarm may beep at the time the alarm
is not set at. Replace the battery in such cases.
ꢀ Connecting the AC adapter
CAUTION:
To avoid risk of fire, and to prevent damage.
INSTRUCTIONS
To a wall outlet
•
Do not use AC adapters except for the
supplied AC adapter.
Plug the AC adapter
only after all connections
are completed.
• Do not use the supplied AC adapter for
other equipment.
EN
AC adapter (supplied)
RA-P31B: AA-R9032 / RA-P30W: AA-R9029
©2008 Victor Company of Japan, Limited
0508KMMCREBET
LVT1848-019A [UW]
Warnings, Cautions and Others
Basic and Common Operations
Thank you for purchasing a JVC product. Please read all instructions carefully before operation, to ensure
your complete understanding and to obtain the best possible performance from the unit.
Caution: Proper Ventilation
Press
Functions
• Light the display screen for 5 seconds when the power is
turned off.
• Temporarily stop the alarm sound when the alarm is ringing
(SNOOZE).
(see “To stop the alarm sound”)
ꢀ Turn on or off the power
ꢀ Adjust the volume
To avoid risk of electric shock and fire, and to prevent damage, locate the apparatus as follows:
1. Front: No obstructions and open spacing.
Press
Functions
Press
Functions
Adjust the volume level from 00 to a
maximum of 20.
2. Sides/ Top/ Back: No obstructions should be placed in the areas shown by the dimensions below.
3. Bottom: Place on the level surface. Maintain an adequate air path for ventilation by placing on a stand
with a height of 10 cm or more.
Turns on or off the power
Disconnect the mains plug to shut the power off
completely. When installing the apparatus ensure
that the plus is easily accessible. The switch in
When the power is turned off at volume level “15”
or higher, the unit automatically sets the volume
level to “14” the next time it is turned on.
–: Turn down the volume.
+: Turn up the volume.
Front
Side
15cm
15cm
any position does not disconnect the mains line.
CAUTION
• Do not block the ventilation openings or holes.
Rating label is placed on the exterior of the bottom.
(If the ventilation openings or holes are blocked
Connector plug
Press
Functions
• Switch on/off the backlight when the
button is held down.
• Switch FM stereo/monaural when FM is
selected.
15cm
15cm
15cm
Press
Functions
by a newspaper or cloth, etc., the heat may not
be able to get out.)
• Do not place any naked flame sources, such as
lighted candles, on the ppparatus.
• When discarding batteries, environmental
problems must be considered and local rules or
laws governing the disposal of these batteries
must be followed strictly.
• Do not expose this apparatus to rain, moisture,
dripping or splashing and that no objects filled
with liquids, such as vases, shall be placed on
the apparatus.
• Switch on/off the SURROUND.
You can enjoy music with
spatial and deep sound in
this mode. (The mode is not
effective when the monaural is
selected.)
• While the clock or the alarm
time are set, return to the
previous item.
FM MODE/
10cm
¢
4
38
(see “Playing back from iPod” and
“Listening to FM Broadcasts”)
[European Union Only]
ꢀ Select a source
Press
Functions
See “How to set the time and
use the alarm”
See “How to set the
Remote control
Select a source
iPod → FM → AUX
time and use the alarm” sensor
ꢀ Display Information
Sound source indicator
When adjusting the volume
iPod/FM/AUX (blinks while muted)
00 - 20
When FM radio is selected
P01 - P20 (channel) /
87.50 - 108.00 MHz (frequency)
When the source is set to iPod and the iPod (slow blinking)
Current time/
alarm time
alarm is set to TIMER PLAY
Date
When the source is set to FM radio and 87.50 - 108.00 MHz ↔ P01-P20
the alarm is set to TIMER PLAY
When battery power is low
When trying to set alarm to TIMER PLAY
while selecting AUX
- - -
Day of the week
ꢀ Explanation of Icons
SURROUND starts lighting when it is switched on.
“STEREO” is displayed when an FM stereo broadcast is received.
Off: current time / On: alarm time
“MONO” is displayed when the monaural is selected. (see “Listening to FM Broadcasts ”)
Off: alarm off / On: alarm on / Blinking: alarm sounding (When “TIMER PLAY” is set)
Current time: Blinking / Other Clock Display: Lighting
Blinks while snoozing (the alarm is paused)
SLEEP Lighting when the sleep mode is selected.
|